The SANIPACK® is a macerator device which is meant to be installed inside a wall cavity. The SANIPACK® is a system that is used to install a complete bathroom up to 15 ft below the sewer line or even up to 150 ft away from a soil stack. It can handle the effluent from a toilet, sink and shower. The SANIPACK® is simplicity itself to install, there are just four connections - the macerator/pump is connected to the discharge pipe coming from a wall hung toilet, the toilet tank is connected to the water supply, The macerator/pump is connected to the small diameter discharge pipe work, the macerator/pump is connected to the electrical supply. The inside of the SANIPACK® is comprised of a pressure chamber, which starts and stops the unit and the motor, which drives the stainless steel macerator blades and the pump. When the flush is activated, the water flowing into the SANIPACK® activates a micro switch in the pressure chamber which in turn starts the motor. The motor is sealed for life in an oil filled enclosure. A common spindle/shaft drives the impeller and the macerator blades. The moving parts therefore are kept to an absolute minimum. Water and organic waste matter enter the chamber and are reduced to slurry as the macerator blades rotate at 3600 rpm. The centrifugal force causes the reduced solids to be ejected through a grill into the container where it is picked up by the impeller pump mounted beneath the motor. The unit pumps the effluent upward to 15 ft and/or 150 ft horizontally (with gravity fall). Once the water is discharged and the water level in the container goes down, the micro switch deactivates the unit until the flush is activated again. A normal operating cycle for SANIPACK® takes about 7-9 s depending upon the discharge pipe run configuration, power consumption is therefore minimal. In addition to the toilet waste, the SANIPACK® will also discharge gray water from a variety of other sanitary fixtures such as - a sink, a shower and a urinal. When adding a shower, a base will have to be constructed. This base should be made out of a 2 x 6 in (minimum) or 2 x 8 in (recommended) on edge, to allow for the installation of a P-trap and the required 1/4 in/ft gravity flow towards the pump unit. The wastewater from other sanitary fixtures is discharged into the SANIPACK® via two 1-1/2 in inlets on either side of the housing. Either one or both inlets can be used as required. The discharge elbow on top of the SANIPACK® can be turned either to the left, to the right or towards the back, depending on the discharge installation. A non-return valve, which comes already assembled on the discharge elbow, prevents back flow into the unit. This unit has been designed with a vent connection on the lid. All plumbing codes require connection to a vent system. Please note that the vent system should be a two-way air vent. The use of mechanical vents, air admittance valves or similar devices are not permitted as these are considered one-way air vent systems. It is also highly recommended for the macerator/pump to be connected to a Ground Fault Interrupter (GFI) circuit. The SANIPACK® is designed to be used with a wall hung toilet. The depth of the case allows for this pump to be installed within the wall. Since the reservoir, the macerating pump and the pipes are hidden from view, this type of installation gives you the lean and clean look of a European bathroom.

Saniflo® SANIPACK® Macerator Pump, 17 gpm, 1-1/2 in Inlet, 3/4 in Outlet, 15 ft Maximum Head, 0.3 hp, 115 VAC, 4.5 A, 60 Hz, 3600 rpm Motor, Wall Mount, 104 deg F, 16-3/4 in W x 4-3/4 in D x 11 in H, Import

• Designed to work with any wall-hung toilet not supplied by Saniflo®
• Mix and match your fixtures (shower, sink) from different brands and choose any wall hung toilet to create your personalized one of a kind bathroom
• The macerating system is easy to conceal with versatile and quiet operation
• As the pump and pipes are hidden inside the wall this type of installation gives you the clean look of a european bathroom

• Catalog https://hs-beta.cimm2.com//ASSETS/DOCUMENTS/ITEMS/EN/https://assets.unilogcorp.com/2/ITEM/DOC/Saniflo_008_Catalog.pdf
• Instruction/Installation Manual https://hs-beta.cimm2.com//ASSETS/DOCUMENTS/ITEMS/EN/https://assets.unilogcorp.com/2/ITEM/DOC/Saniflo_011_Manual.pdf