Sioux Chief's copper plated stub out bracket shall be used where necessary to support 1/2, 3/4 or 1 in nominal copper stub outs for water supply lines. Holes for positioning copper tube shall be located on 2 in or 4 in center lines depending on model number. Bracket shall be produced from cold-roll steel, copper plated and include aprotective water based clear coat finish to minimize surface rust when arriving at jobsite. Depending on model number, bracket may feature extruded holes, providing a wider soldering surface. Bracket may also feature rolled edges to provide additional strength.

Tomahawk Stub Out Bracket, Series: 521, 25 lb, Steel, Copper Plated, 20 in L x 1-1/4 in H, Domestic

• Extruded model provides four time the soldering surface for extra strength
• Heat the tube, not the bracket
• Using approved hardware, secure bracket with nail or screw to stub through pilot hole
• Insert copper stub out into pipe hole, apply flux and solder copper making sure to heat the tube, not the bracket
• Excessive heat applied directly to bracket could result in burning off the plated finish
• 1/2 in hole on 2 in center
• 16 ga steel

• https://externalassets.unilogcorp.com/ASSETS/DOCUMENTS/ITEMS/EN/Sioux_521-118_Specification_Sheet.pdf https://hs-beta.cimm2.com//ASSETS/DOCUMENTS/ITEMS/EN/https://externalassets.unilogcorp.com/ASSETS/DOCUMENTS/ITEMS/EN/Sioux_521-118_Specification_Sheet.pdf